Aspect Ratio Calibration
July 4th, 2009
i've found a bug where as i'm calibrating the screen settings and get to calibrating the ar (trying to get a perfect square) it will let me make the square thin (the number goes up) but then i cannot make it much fatter (the number goes down). so say it starts at 1.099 and i move it to 1.35 it will only let me get back down to about 1.32.
edit: i looked into it more and to explain it better, i can change the ratio to be higher, but not much lower. and this applies to whatever it's set at. however past 1.3 it seems to go to 1.27 and no lower. (from 1.4 i can go to 1.27, from 1.5 i can go to 1.27, etc.)
i hope this can be resolved. the only way to get it back closer to it's default is to delete the settings from the ms dash. (i still can't go lower than the default tho.) i'm using a 1.5 pal xbox on a pal only tv with no pal-60 support (the problem occurs with both pal-60 enabled and disabled.)
if need be, i can capture a small video to show you what i mean. (3 seconds of video would be enough i think)
morien
#If you have any other info about this subject , Please add it free.# |
